Release date 07.10.2021
Viovandt UV Purification
Model Overview
Introduction
- Power connection to Class 2 power supply
- Indicator light
- Water outlet
- Water inlet
Specifications
Certification | NSF/ANSI-55 Class “B” and NSF/ANSI 372 |
Dose Delivery | >16 mJ/cm2 |
Certified Flow Rate | 1.0 L/min |
Water Inlet Fitting | ¼” OD Push-to-Connect |
Water Outlet Fitting | ¼” OD Push-to-Connect |
Input Voltage | 11-16V DC |
Power Consumption (Active) | Approx. 5.0W |
Power Consumption (Standby) | Approx. 0.1W |
Maximum Water Temperature | 40oC |
Maximum Working Pressure | 100 PSI |
Minimum Working Pressure | 12 PSI |
LED Life-time | 1,000 hr (on demand) |
Box Contents
- 1 X Acuva Eco – UV
- 1 X Power adaptor
- 1 X DIN Rail
- 1 X US Power Cable
- 1 X EU Cable (EU ONLY)
- 1 X UK Cable (UK only)
- 1 X Manual
Indicator Light
The indication light shows various modes of use.
- No Light: The device is idle, or no power is connected.
- Blue Light: The device is active and disinfecting water.
- Red Light: There is a fault in the device.
Mounting the Unit
The Din rail should be attached securely to the surface the unit will be installed on using appropriate fixings for both the wall material and to hold the weight of the unit.
The rail orientation should ensure the unit will be installed in one of the configurations below.
Mounting the Unit to rail
- Engage the spring-loaded mechanism of the mounting clips on the device by hooking the clip onto the bottom edge of the DIN-rail and applying slight pressure upwards.
- As the bottom portion engages, tilt the upper hook towards the DIN-rail.
- Release the spring mechanism once the unit is mounted on the rail.
- DIN Rail
- Spring-loaded mechanism
Safety Information and Warnings
This section contains important information regarding the safe installation and operation of the Eco UV 1.0.
PLEASE READ CAREFULLY.
- Installation or operation of the device in a manner contrary to this manual may result in property damage or personal injury.
- Warnings and Safety Precautions
DANGER
- Device must be connected to a Class 2 power supply (12V DC ± 5%, 0.5A output) Do not store the device in freezing conditions.
- Do not allow water to freeze in the device.
- Do not use the device if damaged or dropped. Do not submerge the device under water.
- Do not connect to AC power without an AC to DC power adapter; this device uses DC via Class 2 power supply only.
- This product is not ignition protected. Do not install in an engine compartment or other areas where explosive vapours may be present.